CYBEX Cloud Q User Manual

The FAA recommends that children up to 40 pounds
(18 kg) use a certied, harnessed child seat while travelling
on an airplane. The Cloud Q is certied for airplane use.
INSTALLING THE CARRIER ON AIRPLANE
Install your Infant Carrier in a window seat to avoid blocking the
aisle.
1. Position Infant Carrier rear facing in aircraft seat with the
foot end rmly against the back of the aircraft seat.
2. Route lap belt under both Belt Guides. BUCKLE THE BELT.
3. Push Infant Carrier rmly into aircraft seat
while removing slack from the lap belt.
4. Check the recline angle. Adjust the seat angle until the red
Level Line on the Infant Carrier is level with the oor of the
aircraft. A tightly rolled airline blanket may be placed under
the Infant Carrier to adjust the angle. See page 43.
5. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2.5 cm) in any direction.
If the Infant Carrier moves too much, tighten the airplane belts more
and recheck. If you plan to use the Base at your destination, don't
forget to gate check the Base or check it in as luggage.
(aircraft)
(aircraft oor)
44
1
3
4
2
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
CLICK!
DO NOT USE the Base on airplane.
ALWAYS have the handle locked in the DRIVE position
while using this child restraint on aircraft.
NEVER use the L.S.P. device on airplane.
USING THE INFANT CARRIER ON AIRPLANE
EN

CYBEX Cloud Q Specifications

General

Certification	ECE R-44/04, Supplement 7
Mounting type	ISOFIX
Product color	Gold
Car seat group	0+ (0 - 13 kg; 0 - 15 months)
Adjustable backrest	Yes
Belt fastening type	5-point

Weight and Dimensions

Depth	665 mm
Width	440 mm
Weight	5400 g
Height (max)	570 mm
Height (min)	403 mm