MB95710M Series
MB95770M Series
Document Number: 002-09307 Rev. *D Page 5 of 172
UART/SIO
3 channels
• Data transfer with UART/SIO is enabled.
• It has a full duplex double buffer, variable data length (5/6/7/8 bits), an internal baud rate generator
and an error detection function.
• It uses the NRZ type transfer format.
• LSB-first data transfer and MSB-first data transfer are available to use.
• Both clock asynchronous (UART) serial data transfer and clock synchronous (SIO) serial data transfer
are enabled.
I
2
C bus
interface
1 channel
• Master/slave transmission and reception
• It has the following functions: bus error function, arbitration function, transmission direction detection
function, wake-up function, and functions of generating and detecting repeated START conditions.
8/16-bit PPG
2 channels
• Each channel can be used as an “8-bit timer × 2 channels” or a “16-bit timer × 1 channel”.
• The counter operating clock can be selected from eight clock sources.
16-bit reload
timer
1 channel
• Two clock modes and two counter operating modes are available to use.
• It can output square wave.
• Count clock: it can be selected from internal clocks (seven types) and external clocks.
• Two counter operating modes: reload mode and one-shot mode
Event counter
• The event counter function is implemented by configuring the 16-bit reload timer and 8/16-bit com-
posite timer ch. 1.
• When the event counter function is used, the 16-bit reload timer and 8/16-bit composite timer ch. 1
become unavailable.
LCD controller
(LCDC)
• COM output: 4 or 8 (max) (selectable)
• SEG output: 36 or 40 (max) (selectable)
- If the number of COM outputs is 4, the maximum number of SEG outputs is 40, and the
maximum number of pixels that can be displayed 160 (4 × 40).
- If the number of COM outputs is 8, the maximum number of SEG outputs is 36, and the
maximum number of pixels that can be displayed 288 (8 × 36).
• LCD drive power supply (bias) pins: 5 (max)
• Duty LCD mode
• LCD standby mode
• Blinking function
• Internal divider resistor whose resistance value can be selected from 10 kΩ or 100 kΩ through software
• Interrupt in sync with the LCD module frame frequency
• Inverted display function
Watch counter
• Count clock: four selectable clock sources (125 ms, 250 ms, 500 ms or 1 s)
• The counter value can be selected from 0 to 63. (The watch counter can count for one minute when
the clock source is one second and the counter value is set to 60.)
Watch prescaler Eight different time intervals can be selected.
Comparator 1 channel
Part number
Parameter
MB95F714J MB95F716J MB95F718J MB95F714M MB95F716M MB95F718M
To Next Page
Loading...
