Cypress MB95710M Series - 22 Electrical Characteristics; Absolute Maximum Ratings

MB95710M Series
MB95770M Series
Document Number: 002-09307 Rev. *D Page 131 of 172
22. Electrical Characteristics
22.1 Absolute Maximum Ratings
*1: These parameters are based on the condition that V
SS is 0.0 V.
*2: V
1 and V0 must not exceed VCC + 0.3 V. V1 must not exceed the rated voltage. However, if the maximum current
to/from an input is limited by means of an external component, the I
CLAMP rating is used instead of the VI rating.
*3: Specific pins: P00 to P07, P10, P11, P13 to P16, P20 to P22, P40 to P43, P50 to P53, P60 to P67, P90 to P94, PA0
to PA7, PB0 to PB4, PC0 to PC7, PE0 to PE7, PF0, PF1, PG1, PG2 (P40 to P43, P50 to P53, P94, PB2 to PB4 and
PC4 to PC7 are only available on the MB95710M Series.)
• Use under recommended operating conditions.
• Use with DC voltage (current).
• The HV (High Voltage) signal is an input signal exceeding the V
CC voltage. Always connect a limiting resistor between
the HV (High Voltage) signal and the microcontroller before applying the HV (High Voltage) signal.
Parameter Symbol
Rating
Unit Remarks
Min Max
Power supply voltage*
1
VCC VSS − 0.3 VSS + 6V
Input voltage*
1
VI VSS − 0.3 VSS + 6V*2
Output voltage*
1
VO VSS − 0.3 VSS + 6V*2
Maximum clamp current I
CLAMP −2 +2 mA Applicable to specific pins*
3
Total maximum clamp
current
Σ|ICLAMP| — 20 mA Applicable to specific pins*
3
“L” level maximum
output current
I
OL —15mA
“L” level average current I
OLAV —4mA
Average output current =
operating current × operating ratio (1 pin)
“L” level total maximum
output current
ΣIOL — 100 mA
“L” level total average
output current
ΣIOLAV —50mA
Total average output current =
operating current × operating ratio
(Total number of pins)
“H” level maximum
output current
I
OH — −15 mA
“H” level average
current
I
OHAV — −4mA
Average output current =
operating current × operating ratio (1 pin)
“H” level total maximum
output current
ΣIOH — −100 mA
“H” level total average
output current
ΣIOHAV — −50 mA
Total average output current =
operating current × operating ratio
(Total number of pins)
Power consumption P
d — 320 mW
Operating temperature T
A −40 +85 °C
Storage temperature T
stg −55 +150 °C