MB95710M Series
MB95770M Series
Document Number: 002-09307 Rev. *D Page 130 of 172
*9: On the MB95770M Series, TO00 is assigned to P01, TO0 to P10, TO01 to P13, and EC0 and TI0 to P14.
*10: Though input is blocked, an external interrupt can be input when the external interrupt request is enabled.
*11: The output function of the comparator is still in operation in stop mode and watch mode.
*12: Though input is blocked, an analog signal can also be input to generate a comparator interrupt when the comparator
interrupt is enabled.
*13: The I
2
C bus interface can wake up the MCU in stop mode or watch mode when its MCU standby mode wakeup
function is enabled. For details of the MCU standby mode wakeup function, refer to “CHAPTER 23 I
2
C BUS INTER-
FACE” in “New 8FX MB95710M/770M Series Hardware Manual”.
*14: P40/SEG21, P41/SEG20, P42/SEG19, P43/SEG18, P50/TO01, P51/EC0, P52/TI0/TO00, P53/TO0, P94/V0,
PB2/SEG37, PB3/SEG38, PB4/SEG39, PC4/SEG06, PC5/SEG07, PC6/SEG08 and PC7/SEG09 are only avail-
able on the MB95710M Series.
SEG17 P67 PE3
SEG18 P43 PE4
SEG19 P42 PE5
SEG20 P41 PE6
SEG21 P40 PE7
SEG22 PE0 P07
SEG23 PE1 P06
SEG24 PE2 P05
SEG25 PE3 P04
SEG26 PE4 P03
SEG27 PE5 P02
SEG28 PE6 P01
SEG29 PE7 P00
SEG30 P07 P16
SEG31 P06 P15
SEG32 P05 —
SEG33 P04 —
SEG34 P03 —
SEG35 P02 —
SEG36 P01 —
SEG output Pin on MB95710M Series Pin on MB95770M Series
To Next Page
Loading...
