To Next Page
E
Eric PierceSep 10, 2025
What to do if my Cytiva Laboratory Equipment rocker does not initialize properly?
- KkjonesSep 12, 2025
If the system does not initialize properly, try restarting it a few times.
What to do if my Cytiva Laboratory Equipment rocker does not initialize properly?
If the system does not initialize properly, try restarting it a few times.
Why are there incorrect readings in dual mode on my Cytiva Laboratory Equipment?
Incorrect readings in dual mode can occur if Cellbag bioreactors are not centred on the respective halves of the tray or if the tare was omitted or incorrectly performed. Check bioreactor placement. Tare the scale before or after filling the Cellbag bioreactors.
General| Model | Xuri W25 |
|---|---|
| Type | Cell Culture System |
| Cell Culture Capacity | up to 25 L |
| Working Volume Range | 5-25 L |
| pH Control | Yes |
| Dissolved Oxygen Control | Yes |
| Agitation Type | Rocking |
| Sterilization | Gamma-irradiated, ready-to-use |
| Material | Single-use Cellbag bioreactor |
| Description | The Xuri W25 is a single-use cell expansion system designed for adherent and suspension cell culture. |
Covers critical safety instructions, intended use, prerequisites, and safety notices for users.
Lists related documents for the Xuri Cell Expansion System W25, including operating instructions and guides.
Provides a general overview of the Xuri Cell Expansion System W25 and its intended use for cell cultivation.
Details the rocker as the main system unit, its functions, and rocking parameters.
Introduces the CBCU control unit and its configurations, showing front panel components.
Describes the Cellbag bioreactor, its options, and shows an illustration of its components.
Gives an overview of the UNICORN software and its help utility, listing sections within.
Details the System Control module for starting, viewing, and controlling runs, including its panes.
Covers creating and working with methods and text instructions in UNICORN.
Introduces the principles of pH and DO measurement and control in the Xuri Cell Expansion System W25.
Covers media control modes (Media addition, Perfusion) and references for settings.
Guides on preparing the bioreactor system for cell cultivation, referring to system description.
Guides on starting the system, logging into UNICORN, connecting, and configuring the system in software.
Covers preparing the system for cell cultivation, including bioreactor and sensor preparation.
Describes the basics of performing a cultivation, monitoring parameters and adjusting settings.
Outlines the calibration schedule before cultivation and when required, including scale and sensor calibrations.
Explains pump calibration procedures, tube inner diameter importance, and rate modes.
Addresses troubleshooting for rocker issues like initialization, rocking, angle, speed, and power button errors.
Covers general CBCU error symptoms, gas flow issues, and CO2/O2 mix problems.
Introduces troubleshooting for UNICORN software issues, listing specific modules.
Lists the overall system specifications for Xuri Cell Expansion System W25, including configuration and supply requirements.
Details equipment dimensions, weights, and specific specifications for the Rocker unit.
States this section lists various control settings configurable in UNICORN.
