D.A.C.E SPRINT - Setting Party Mode (Auto-Close Overide); Auto-Close

20
SETTINGPARTYMODE(AUTOCLOSEOVERIDE)
Partymodeistheautocloseoverridemode.Thismeansthatthe gatewillremainopenandignorethe
autoclosetime.
Tosetpartymode:
Pressandholdtheremotebuttondown.Thegatewillopenimmediately.Continueholdingdownfor15
secondsuntiltheLCDdisplaysPARTYMODE.
Toresetthegatetonormaloperation:
Presstheremotebuttontwicewithintwoseconds.
Thegatewillstarttoclose.ThegateisnowinnormalmodeagainandwillusetheAutoclos efunction.
AUTO-CLOSE
Auto-close is an option that allows the gate to close automatically after a chosen time delay, this delay
can be from 10 to 70 seconds. Auto-close is selected by using the dipswitches on the main PC Board.
Dipswitch numbers 6,7 and 8 are the auto-close time select switches. The times are as follows.
6 off ; 7 off; 8 off = no auto-close
6 on; 7 off; 8 off = 10 seconds
6 off; 7 on; 8 off = 20 seconds
6 off; 7 off; 8 on = 40 seconds
6 on; 7 on; 8 on = 70 seconds
Any combination can be used to select the d
esired auto-close time.
It is strongly recommended that BMG safety beams are used when Auto-Close is
selected as this reduces the chance of the gate closing on an object and causing
injury or damage.
No’s 6; 7 & 8: SETTING AUTO-CLOSE