D-Link AC1200 - Settings; Internet; WAN

DIR-842V2 AC1200 Wi-Fi Gigabit Router
User Manual
Configuring via Web-based Interface
Page 67
Settings / Internet
WAN
On the Settings / Internet / WAN page, you can create and edit connections used by the router.
By default, a Dynamic IPv4 connection is configured in the system. It is assigned to the WAN
port of the router.
Figure 62. The Settings / Internet / WAN page. The simplified mode.
To edit an existing connection, click the EDIT button. Change the needed parameters and click the
APPLY button.
To disconnect a connection and establish it again, click the RECONNECT button.
To remove an existing connection and create a new one, click the CHANGE CONFIGURATION
button. Upon that the connection creation page opens.
To create several WAN connections, go to the advanced mode. To do this, click the ADVANCED
MODE button.
!
When connections of some types are created, the Settings / Internet / WAN page is
automatically displayed in the advanced mode.