10D-Link DIR-890L User Manual
Section 2 - Choosing an Operation Mode
Existing Wi-Fi Coverage Wi-Fi Coverage with DIR-890L
What is an Access Point?
In Access Point Mode, the DIR-890L works with your existing networking equipment to provide Wi-Fi for parts of your home or oce that may
have poor or no reception. You may use the DIR-890L as a wireless access point by connecting it to an uplink network via an Ethernet cable. This
can be useful if you already have an existing router without built-in wireless capabilities or if your existing wireless signal can’t bridge the distance.
Devices connected to the DIR-890L obtain IP addresses from the existing uplink network.
Place the DIR-890L in an area where you wish to get Wi-Fi, but is reachable by Ethernet cable from your uplink network.
Access Point Mode
To Next Page
Loading...
