D-Link AC3200 Ultra - Page 60

55D-Link DIR-890L User Manual
Section 4 - Conguration - Router Mode
Advanced Settings - Address Autoconguration Settings
Enable Automatic
IPv6 Address
Assignment:
Enable or disable the Automatic IPv6 Address Assignment feature.
If DHCP-PD is available and enabled in LAN IPv6 Address Settings:
Enable Automatic
DHCP-PD in LAN:
Enable or disable DHCP-PD for other IPv6 routers connected to the
LAN interface. Note: This feature requires a smaller subnet prex than
/64 (i.e. allowing for a larger address allocation), such as /63. Contact
your ISP for more information.
Autoconguration
Type:
Select SLAAC+RDNSS, SLAAC+Stateless DHCP, or Stateful DHCPv6.
If you selected SLAAC+RDNSS or SLAAC+Stateless DHCP as the Autoconguration Type:
Router
Advertisement
Lifetime:
Enter the router address advertisement lifetime (in minutes).
If you selected Stateful DHCPv6 as the Autoconguration Type:
IPv6 Address
Range (Start):
Enter the starting IPv6 address for the DHCP server’s IPv6 assignment.
IPv6 Address
Range (End):
Enter the ending IPv6 address for the DHCP server’s IPv6 assignment.
IPv6
Advertisement
Lifetime:
Enter the IPv6 address lifetime (in minutes).
Click Save when you are done.
PPPoE(continued)
ADDRESS AUTOCONFIGURATION SETTINGS
Enable Automatic IPv6 Address Assignment:
Enabled
Enable Automatic DHCP-PD in LAN:
Enabled
Autoconguration Type:
SLAAC+Stateless DHCP
⌵
Router Advertisement Lifetime: minutes
ADDRESS AUTOCONFIGURATION SETTINGS
Enable Automatic IPv6 Address Assignment:
Enabled
Enable Automatic DHCP-PD in LAN:
Enabled
Autoconguration Type: SLAAC+RDNSS
⌵
Router Advertisement Lifetime:
minutes
ADDRESS AUTOCONFIGURATION SETTINGS
Enable Automatic IPv6 Address Assignment:
Enabled
Enable Automatic DHCP-PD in LAN:
Enabled
Autoconguration Type: Stateful DHCPv6
⌵
IPv6 Address Range (Start): xxxx ::00 3
IPv6 Address Range (End): xxxx ::00
16
Router Advertisement Lifetime:
minutes