D-Link AC3200 Ultra - Page 70

65D-Link DIR-890L User Manual
Section 4 - Conguration - Router Mode
If Smart Connect is Disabled the following options are available:
2.4GHz / Primary 5GHz / Secondary 5GHz
Status: Enable or disable the 2.4 GHz and 5 GHz wireless networks.
Wi-Fi Name (SSID): Create a name for your wireless network using up to 32 characters.
Password: Create a password to use for wireless security.
Advanced Settings
Security Mode: Choose None, WEP, or WPA/WPA2-Personal (recommended).
802.11 Mode
(2.4 GHz):
Select the desired wireless networking standards to use.
The available options for the 2.4 GHz wireless network are Mixed
802.11b/g/n, Mixed 802.11g/n, 802.11n only.
802.11 Mode
(5 GHz):
Select the desired wireless networking standards to use.
The available options for the 5 GHz wireless network are Mixed
802.11a/n/ac, Mixed 802.11n/ac, 802.11ac only, Mixed 802.11a/n,
Mixed 802.11n only, or 802.11a only.
Wi-Fi Channel: Select the desired channel. The default is Auto (recommended).
Transmission
Power:
Select the desired wireless transmission power.
Channel Width
(2.4 GHz):
Select Auto 20/40 if you are using both 802.11n and non-802.11n
devices, or select 20 MHz if you are not using any 802.11n devices.
Channel Width
(5 GHz):
Select Auto 20/40/80 if you are using 802.11ac, 802.11n, and 802.11a
devices, select Auto 20/40 if you are using 802.11n and 802.11a
devices, or select 20 MHz if you are only using 802.11a devices.
Wireless - Smart Connect Disabled
Smart Connect
Smart Connect:
Disabled
DIR-890L HW:A1 FW:1.10
Settings >> Wireless
SettingsHome
Wireless
Features Management
Use this section to congure the wireless settings for your D-Link Router. Please make sure that any
changes made in this section will need to be updated on your wireless device.
Guest Zone
Save
2.4GHz
Advanced Settings ...
Status:
Enabled
Wi-Fi Name (SSID): Your_2.4G_Wi-Fi_Network
Password:
A_Str0nG_P@ssW0rd!%!
Security Mode:
WPA/WPA2-Personal
⌵
802.11 Mode: Mixed 802.11b/g/n
⌵
Wi-Fi Channel: Auto
⌵
Transmission Power: High
⌵
Channel Width:
Auto 20/40 MHz
⌵
HT20/40 Coexistence:
Enabled
Visibility Status: Visible
⌵
Schedule: Always Enable
⌵
Primary 5GHz
Advanced Settings ...
Status:
Enabled
Wi-Fi Name (SSID): Your_Primary_5G_Wi-Fi_Network
Password:
A_Str0nG_P@ssW0rd!%!
Security Mode:
WPA/WPA2-Personal
⌵
802.11 Mode: Mixed 802.11a/n/ac
⌵
Wi-Fi Channel: Auto
⌵
Transmission Power: High
⌵
Channel Width: Auto 20/40/80 MHz
⌵
Visibility Status: Visible
⌵
Schedule: Always Enable
⌵