D-Link DAP-2695 - Hardware Overview; Leds; Connections

7D-Link DAP-2695 User Manual
Section 1 - Product Overview
Hardware Overview
LEDs Connections
1 2 3 4 5
1 Reset Button
Press and hold for six seconds to reset the access point
to the factory default settings.
2 Console Port
Connect the supplied console cable to congure
using a command line interface.
3 LAN2 Port Connect to your network with an Ethernet cable.
4 LAN1 (PoE) Port
Connect to a Power over Ethernet (PoE) switch or
router.
5 Power Receptor
Connect the supplied power adapter.
(*Note no longer used, replaced by PoE)
1 5GHz
When lit, the access point is operating at 5GHz. This light
will blink when there is wireless trac.
2 2.4GHz
When lit, the access point is operating at 2.4GHz. This
light will blink when there is wireless trac.
3 LAN1 (PoE)
Solid light when the Ethernet port is connected to a
power over Ethernet (PoE) port, such as a router or
switch. The light will blink when there is trac through
LAN port.
4 LAN2
Solid light when the Ethernet port is connected to a
working port, such as a router or switch. The light will
blink when there is trac through LAN port.
5 Power
The light will blink during boot up. Once solid, the access
point is ready.
1 2 3 4 5