D-Link DCS-2103 User Manual

14D-Link DCS-2103 User Manual
Section 2: Installation
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on
the panel at the rear of the DCS-2103 and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC Power receptor located on the rear
panel of the DCS-2103 and connect it to your wall outlet or power strip.
Note: If you choose to take advantage of the Power over Ethernet feature you
may unplug the power cable.
Manual Hardware Installation
If you wish to set up your camera without using the Camera Setup Wizard, please follow these steps.

D-Link DCS-2103 Specifications

General

Brand	D-Link
Model	DCS-2103
Category	Security Camera
Language	English