D-Link DCS-2332L - Removing the Bottom Panel; Using the Reset Button

15D-Link DCS-2332L User Manual
Section 1: Product Overview
Removing the Bottom Panel
Step 1:
Place the camera face down on a non-slip at surface.
Step 2:
Carefully pry out the two protective rubber screw coverings using a thin at blade.
Step 3:
Undo the two screws using a Phillips Screwdriver.
Step 4:
Lift o the protective panel.
Using the Reset Button
Step 1:
Follow the steps outlined above in Removing the Bottom Panel.
Step 2:
Using a paperclip or similar tool, press and hold the Reset Button for 10 seconds. This will
reset the device to it's factory settings.
Step 3:
Follow the steps outlined in Reattaching the Bottom Panel on page 16.
2
2
3
4