D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch
12
Mounting the Switch on a Rack
The DGS-1016D/1024D can easily be mounted on a rack.
Two mounting ears are provided for this purpose. Make sure
that the front panel is exposed in order to view the LEDs.
Please refer to the
following illustrations:
Figure 2-1. Mounting the Switch to a Rack
A. Attach the ears to each side of the Switch, using the
screw-holes located on the side of the device.
B. Firmly attach the ears to the rack as shown. Please
follow the usual safety precautions for rack-mountable
products
Attaching the Rubber Feet
Use rubber feet provided. Position and apply rubber feet to the
underside of the DGS-1016D/1024D Switch.
To Next Page
Loading...
