D-Link DGS-1016D - Power on

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch
14
Power On
Plug one end of the AC to DC power converter into the power
connector of the Switch and the other end into the local power
source outlet.
After the Switch is powered on, the LED indicators will
momentarily blink. This blinking of the LED indicators
represents a reset of the system.
Power Failure
As a precaution, in the event of a power failure, unplug the
Switch. When power is resumed, plug the Switch back in.