D-Link DGS-1016D - Connecting to Hubs or Switches

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch
17
Switch to Hub or Switch
These connections can be accomplished in a number of ways
using a standard Ethernet cable.
• A 10BASE-T hub or switch can be connected to the
Switch via a twisted-pair Category 3, 4, 5, or 5e
UTP/STP cable.
• A 100BASE-TX hub or switch can be connected to the
Switch via a twisted -pair Category 5 UTP/STP cable.
• A 1000BASE-T switch can be connected to the Switch
via a twisted -pair Category 5e or better UTP/STP
cable.
Figure 3-2. Switch connected to a port on a hub or switch using
either a straight or crossover cable–any standard Ethernet cable
is fine.