D-Link DGS-108 Manual

D-Link DGS-105/108 Gigabit Ethernet Switch
iv
Preface
The DGS-105/108 Manual is divided into sections that describe the system installation and operating instructions with
examples.
Section 1, Introduction - A description of the physical features of the Switch, including LED indicators, ports and
panel descriptions.
Section 2, Installation – A description of the physical installation of the Switch including connecting the Switch to
the network and connecting stacked switch groups.
Section 3, Connecting the Switch – A description of how to connect your Switch to an end node, hub, Switch, or
backbone server.
Appendix A, Technical Specifications - The technical specifications of the DGS-105/108.
Glossary – Lists definitions for terms and acronyms used in this document.
Intended Readers
The DGS-105/108 Manual contains information for setup and management and of the DGS-105/108 Switch. This manual
is intended for network managers familiar with network management concepts and terminology.
Notes, Notices, and Cautions
NOTE: A NOTE indicates important information that helps you make better use of your device.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you
how to avoid the problem.
CAUTION: A CAUTION indicates the potential for property damage, personal injury, or death.

D-Link DGS-108 Specifications

General

MAC address table	8000 entries
Jumbo frames support	Yes
Packet buffer memory	0.128 MB
Maximum data transfer rate	1 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
Dimensions (WxDxH)	162 x 102 x 28 mm
Connectivity technology	Wired
10G support	-
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Switch type	Unmanaged
Switch layer	L2
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Certification	FCC Class B, ICES-003 Class B, CE Class B, C-Tick Class B, VCCI Class B, cUL, CB, RoHS
Product color	Black
Rack mounting	No
LED indicators	Link, Power, Y
Housing material	Metal
Input current	1 A
Input voltage	5 V
Power consumption (typical)	4.5 W
Mean time between failures (MTBF)	2053751 h
Heat dissipation	9.548 BTU/h
Storage temperature (T-T)	10 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Weight	440 g