3
3
1
1
By entering a System Name and System Location, the device can
more easily be recognized through the SmartConsole Utility and in
other Web-Smart devices on the LAN. The Login Timeout controls
the idle time-out for security purposes, when there is no action in the
Web-based Utility. When the Login Timeout expires, the Web-based
Utility requires a re-login before using the Utility again. The Group
Interval send IGMP v1 report packet by switch, it is for
SmartConsole Utility to discovery our switch when we in IGMP
protocol, zero means disable Group Interval, and 120~1225 means
send IGMP v1 report according the value which unit is seconds.
Figure 23 – System > System Setting
System > Trap Setting
By configuring the Trap Setting, it allows SmartConsole Utility to
monitor specified events on this Web-Smart Switch. By default, Trap
Setting is Disabled. When the Trap Setting is Enabled, enter the
Destination IP address of the managing PC that will receive trap
information.
To Next Page
Loading...
Need help?
General