xStack DGS-3400 Series Fast Ethernet Switch
The following parameters can be set, for the Ethernet type:
Parameter Description
Profile ID (1-6)
Type in a unique identifier number for this profile set. This value can be set
from 1 - 6.
Type
Select profile based on Ethernet (MAC Address), IP or IPv6 address. This will
change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
packet header.
Select IP to instruct the Switch to examine the IP address in each frame's
header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's
header.
VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of
each packet header and use this as the full or partial criterion for forwarding.
Source MAC
Source MAC Mask - Enter a MAC address mask for the source MAC address.
Destination MAC
Destination MAC Mask - Enter a MAC address mask for the destination MAC
address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value
of each packet header and use this as the, or part of the criterion for
forwarding.
Ethernet type
Selecting this option instructs the Switch to examine the Ethernet type value in
each frame's header.
The page shown below is the IP Access Profile Configuration page.
Figure 7- 42. Access Profile Configuration (IP)
121
To Next Page
Loading...
