xStack DGS-3400 Series Fast Ethernet Switch
Routing Table
The Switch supports static routing for IP and IPv6 formated addressing. Access both menus in the Routing Table folder.
Static/Default IP Route Settings
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding
is accomplished by the entry of an IP address into the Switch’s Static IP Routing Table. To view the following window,
click Administration > Routing Table > Static/Default Route.
Figure 6- 27. Static/Default Route Settings window
This window shows the following values:
Parameter Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Metric
Represents the metric value of the IP interface entered into the table. This field
may read a number between 1-65535.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface.
Backup State
Represents the Backup state that this IP interface is configured for. This field may
read Primary or Backup.
Delete
Click the button if you would like to delete this entry from the Static/Default
Route Settings table.
53
To Next Page
Loading...
