xStack DGS-3400 Series Fast Ethernet Switch
Static IPv6 ARP Settings
Static ARP entries can be defined for IPv6 addresses. This will create a permanent entry is entered and is used to translate
IPv6 address to MAC addresses.
To open the Static IPv6 ARP Table open the Administration folder, and then open the Static ARP folder and click on
the Static IPv6 ARP Settings link.
Figure 6- 25. Static IPv6 ARP Settings table
To remove an entry, click the Delete button for the entry being removed. To completely clear the Static IPv6 ARP
Settings, click the Clear All button. To add a new entry, click the Add button, revealing the following screen to configure:
Figure 6- 26. Static IPv6 ARP Settings – Add menu
The following fields can be set or viewed:
Parameter Description
IPv6 Address
The IPv6 address of the ARP entry. Specify the address using the format as
ipv6address (ipv6address is hexadecimal number, for example
1234::5D7F/32).
MAC Address
The MAC address of the IPv6 ARP entry.
After entering the IPv6 Address and MAC Address of the Static IPv6 ARP entry, click Apply to implement the new entry.
52
To Next Page
Loading...
