D-Link DGS-3620-52P - Page 1142

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1137
SSH> from <ipaddr | ipv6address> authenticated by AAA <local |
server <ipaddr | ipv6address>> (Username: <username>).
Parameters description:
local: specify AAA local method.
server: specify AAA server method.
ipaddr: IP address.
ipv6address: IPv6 address.
username: user name.
WAC
Event description: When a client host fails to authenticate.
Log Message: WAC unauthenticated user (User Name: <string>,
IP: <ipaddr | ipv6address>, MAC: <macaddr>, Port:
<[unitID:]portNum>)
Parameters description:
string: User name
ipaddr: IP address
ipv6address: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Warning
Event description: This log will be triggered when the number of
authorized users reaches the maximum user limit on the whole
device.
Log Message: WAC enters stop learning state.
Warning
Event description: This log will be triggered when the number of
authorized users is below the maximum user limit on whole device
in a time interval (5 min).
Log Message: WAC recovered from stop learning state.
Warning
Event description: When a client host authenticated successful.
Log Message: WAC authenticated user (Username: <string>, IP:
<ipaddr | ipv6address>, MAC: <macaddr>, Port: <[unitID:]
portNum>)
Parameters description:
string: User name
ipaddr: IP address
ipv6address: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Informational
JWAC
Event description: When a client host authenticated successful.
Log Message: JWAC authenticated user (Username: <string>, IP:
<ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Informational