D-Link DGS-3620-52P - Enable Dvmrp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
390
disable - Specifies that DVMRP of the specified IP interface will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To configure DVMRP configurations of IP interface called ‘System’:
DGS-3620-28SC:admin# config dvmrp ipif System neighbor_timeout 30 metric 1
probe 5
Command: config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Success
DGS-3620-28SC:admin#
26-2 enable dvmrp
Description
This command is used to enable the DVMRP global state on the Switch.
Format
enable dvmrp
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable DVMRP:
DGS-3620-28SC:admin# enable dvmrp
Command: enable dvmrp
Success.
DGS-3620-28SC:admin#