D-Link DGS-3620-52P - Show Syslog; Config Syslog Host

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
737
Example
To disable syslog sending a message:
DGS-3620-28SC:admin#disable syslog
Command: disable syslog
Success
DGS-3620-28SC:admin#
67-14 show syslog
Description
This command is used to display the syslog protocol global state.
Format
show syslog
Parameters
None.
Restrictions
None.
Example
To display the syslog protocol global state:
DGS-3620-28SC:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3620-28SC:admin#
67-15 config syslog host
Description
This command is used to configure the syslog host configuration.
Format
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning |
notice | informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 |