D-Link DGS-3620-52P - Page 1144

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1139
vlanID: the VLAN ID number.
Event Description: Port recovered from LBD blocked state under
VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD recovered. Loop
detection restarted
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Informational
Event Description: The number of VLAN in which loop back
occurs hit the specified number.
Log Message:
Loop VLAN number overflow.
Parameters Description:
None
Informational
IMPB
Event description: Dynamic IMPB entry conflicts with static ARP.
Log Message: Dynamic IMPB entry conflicts with static ARP(IP:
<ipaddr>, MAC: <macaddr>, Port <[unitID:]portNum>)
Parameters description:
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Warning
Event description: Dynamic IMPB entry conflicts with static FDB.
Log Message: Dynamic IMPB entry conflicts with static FDB(IP:
[<ipaddr> | <ipv6addr>], MAC: <macaddr>, Port
<[unitID:]portNum>)
Parameters description:
ipaddr: IP address
ipv6addr: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Warning
Event description: Dynamic IMPB entry conflicts with static
IMPB.
Log Message: Dynamic IMPB entry conflicts with static IMPB(IP:
[<ipaddr> | <ipv6addr>], MAC: <macaddr>, Port
<[unitID:]portNum>).
Parameters description:
ipaddr: IP address
ipv6addr: IPv6 address
macaddr: MAC address
Warning