D-Link DGS-3620-52P - Page 120

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
115
Parameters
profile_id - (Optional) Specifies the index of the egress access list profile.
<value 1-4> - Enter the profile ID here. This value must be between 1 and 4.
profile_name - (Optional) Specifies the name of the profile. The maximum length is 32
characters.
<name 1-32> - Enter the profile name here. This name can be up to 32 characters long.
If no parameter is specified, will show the all egress access profile.
Restrictions
None.
Example
To display current egress access list table:
DGS-3620-28SC:admin# show egress_access_profile
Command: show access_profile
Egress Access Profile Table
Total User Set Rule Entries : 3
Total Used Hardware Entries : 3
Total Available Hardware Entries : 253
===============================================================================
=
Profile ID: 1 Profile name: 1 Type: Ethernet
Mask on
Source MAC : FF-FF-FF-FF-FF-FF
Available Hardware Entries : 127
-------------------------------------------------------------------------------
-
Rule ID : 1 Port group: -
Match on
VLAN ID : 1
Source MAC : 00-00-00-00-00-01
Action:
Permit
===============================================================================
=
===============================================================================
=
Profile ID: 2 Profile name: 2 Type: IPv4
Mask on
Source IP : 255.255.255.255