D-Link DGS-3620-52P - Page 181

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
176
12-29 show bgp peer_group
Description
The command is used to show the information of the BGP peer group.
Format
show bgp peer_group {<peer_group_name 16>}
Parameters
peer_group - (Optional) Name of the BGP peer group. The length is up to 16 bytes.
<peer_group_name 16> - Enter the BGP peer group name here. This name can be up to 16
characters long.
It means to display all the BGP peer groups’ information that doesn’t specify the peer group
name.
Restrictions
None. (EI Mode Only Command)
Example
Show the information of the BGP peer group local1:
DGS-3620-28SC:admin# create bgp neighbor peer_group local1
Command: create bgp neighbor peer_group local1
Success.
DGS-3620-28SC:admin# create bgp neighbor 10.2.2.2 remote_as 10
Command: create bgp neighbor 10.2.2.2 remote_as 10
Success.
DGS-3620-28SC:admin# config bgp peer_group local1 add 10.2.2.2
Command: config bgp peer_group local1 add 10.2.2.2
Success.
DGS-3620-28SC:admin# show bgp peer_group local1
Command: show bgp peer_group local1
BGP Peer Group :local1
-----------------------------------------------------------------------
Description :
Session : Enabled
Session Activity : Enabled
Members : 10.2.2.2
Remote AS : Not Set
Advertisement Interval : 30 seconds