xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
178
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to configure the cluster ID:
DGS-3620-28SC:admin# config bgp route_reflector cluster_id 10.100.200.1
Command: config bgp route_reflector cluster_id 10.100.200.1
Success.
DGS-3620-28SC:admin#
12-31 config bgp client_to_client_reflection
Description
This command is used to configure the BGP client to client reflection setting. If the reflection is
disabled, then the router will not reflect routes from the route reflect client to other route reflect
clients, but it will still send routes received from a non-reflecting client to a reflecting client.
Format
config bgp client_to_client_reflection [enable | disable]
Parameters
enable - The reflector will operate in reflector mode.
disable - The reflector will operate in non-reflector mode.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to disable the client to client reflection:
DGS-3620-28SC:admin# config bgp client_to_client_reflection disable
Command: config bgp client_to_client_reflection disable
Success.
DGS-3620-28SC:admin#
To Next Page
Loading...
