xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
188
12-43 show bgp community_list
Description
This command is used to show a BGP community list.
Format
show bgp community_list {<list_name 16>}
Parameters
community_list - Specifies the name of community list to be displayed.
<list_name 16> - (Optional) Enter the community list name here. This name can be up to 16
characters long.
Restrictions
None. (EI Mode Only Command)
Example
This example displays the community list name as list1:
DGS-3620-28SC:admin# create bgp community_list standard list1
Command: create bgp community_list standard list1
Success.
DGS-3620-28SC:admin# config bgp community_list standard list1 add community_set
50000:10 permit
Command: config bgp community_list standard list1 add community_set 50000:10
permit
Success.
DGS-3620-28SC:admin# show bgp community_list list1
Command: show bgp community_list list1
Community List Name: list1
--------------------------------
Type : standard
permit : 50000:10
DGS-3620-28SC:admin#
12-44 show bgp route
Description
This command is used to display route entries in the Border Gateway Protocol (BGP) routing table
To Next Page
Loading...
