xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
201
Example
This is an example of configuring the BGP aggregate next hop check:
DGS-3620-28SC:admin# config bgp aggregate_next_hop_check enable
Command: config bgp aggregate_next_hop_check enable
Success.
DGS-3620-28SC:admin#
12-55 config bgp fast_external_fallover
Description
This command configures a Border Gateway Protocol (BGP) routing process to immediately reset
its external BGP peer sessions if the link used to reach these peers goes down,
Format
config bgp fast_external_fallover [enable | disable]
Parameters
enable - To enable BGP fast external fallover flag. Default is enabled.
disable - To disable BGP fast external fallover.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example disables BGP fast external fallver:
DGS-3620-28SC:admin# config bgp fast_external_fallover disable
Command: config bgp fast_external_fallover disable
Success.
DGS-3620-28SC:admin#
12-56 config bgp neighbor maximum_prefix
Description
This command is used to configure the BGP neighbor maximum prefix.
To Next Page
Loading...
