D-Link DGS-3620-52P - Page 240

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
235
DGS-3620-28SC:admin#
15-26 clear cfm pkt_cnt
Description
This command is used to clear the CFM packet’s RX/TX counters.
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specify the port counters to clear. If not specified, all ports will be cleared.
<portlist> - Specify a list of ports.
rx - (Optional) Clear the RX counter. If not specified, both the RX and TX counters will be
cleared.
tx - (Optional) Clear the TX counter. If not specified, both the RX and TX counters will be
cleared.
rx - (Optional) Clear the RX counter. If not specified, both the RX and TX counters will be
cleared.
tx - (Optional) Clear the TX counter. If not specified, both the RX and TX counters will be cleared.
ccm - (Optional) Clear The CCM RX counters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To clear all the CFM packet RX/TX counters:
DGS-3620-28SC:admin#clear cfm pkt_cnt
Command: clear cfm pkt_cnt
Success.
DGS-3620-28SC:admin#
To clear the CFM packet CCM counters:
DGS-3620-28SC:admin#clear cfm pkt_cnt ccm
Command: clear cfm pkt_cnt ccm
Success.
DGS-3620-28SC:admin#