D-Link DGS-3620-52P - Page 475

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
470
39-6 disable igmp_snooping
Description
This command is used to disable IGMP snooping on the switch. IGMP snooping can be disabled
only if IP multicast routing is not being used. Disabling IGMP snooping allows all IGMP and IP
multicast traffic to flood within a given IP interface.
Format
disable igmp_snooping
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable IGMP snooping:
DGS-3620-28SC:admin#disable igmp_snooping
Command: disable igmp_snooping
Success.
DGS-3620-28SC:admin#
39-7 show igmp_snooping
Description
This command is used to display the current IGMP snooping configuration on the switch.
Format
show igmp_snooping {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
Parameters
vlan - (Optional) Specify the name of the VLAN to display the IGMP snooping configuration.
<vlan_name 32> - Specify the name of the VLAN. The maximum length is 32 characters.
vlanid - (Optional) Specify the VLAN ID to display the IGMP snooping configuration.
<vlanid_list> - Specify a range of VLAN IDs.
Note: If no parameter is specified, the system will display all current IGMP snooping
configuration.