D-Link DGS-3620-52P - Page 477

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
472
<portlist> - Specify a range of ports to be configured.
<ipaddr> - (Optional) Specify the group IP address for which to view IGMP snooping group
information.
Note: If no parameter is specified, the system will display all of the current IGMP
snooping group configuration of the switch.
Restrictions
None.
Example
To display IGMP snooping groups:
DGS-3620-28SC:admin#show igmp_snooping group
Command: show igmp_snooping group
Source/Group : NULL / 224.106.0.211
VLAN Name/VID : default/1
Member Ports : 1
UP Time : 223
Expiry Time : 37
Filter Mode : EXCLUDE
Source/Group : NULL / 234.54.163.75
VLAN Name/VID : default/1
Member Ports : 1
UP Time : 223
Expiry Time : 37
Filter Mode : EXCLUDE
Source/Group : 110.56.32.100 / 235.10.160.5
VLAN Name/VID : default/1
Member Ports : 2
UP Time : 221
Expiry Time : 10
Filter Mode : EXCLUDE
Total Entries : 3
DGS-3620-28SC:admin#
39-9 config igmp_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress IGMP control packets.