xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
667
60-5 show mld_proxy
Description
This command is used to display the MLD proxy’s configuration or group information. The display
status item means group entry is determined by whether or not the chip has been inserted.
Format
show mld_proxy {group}
Parameters
group - (Optional) Specify the group information.
Note: If the group is not specified, the MLD proxy configuration will be displayed.
Restrictions
None.
Example
To display the MLD proxy’s information:
DGS-3620-28SC:admin#show mld_proxy
Command: show mld_proxy
MLD Proxy Global State : Enabled
Upstream Interface
VLAN ID : 1
Dynamic Router Ports : 1-4
Static Router Ports : 5-6
Unsolicited Report Interval : 10
Source IP Address : ::
Downstream Interface
VLAN List : 2-4
DGS-3620-28SC:admin#
To display the MLD proxy’s group information:
DGS-3620-28SC:admin#show mld_proxy group
Command: show mld_proxy group
Source : NULL
Group : FF1E::0202
Downstream VLAN : 4
Member Ports : 3,6
Status : Active
To Next Page
Loading...
