xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
703
Restrictions
None.
Example
To display the MLD configurations on all interfaces:
DGS-3620-28SC:admin# show mld
Command: show mld
MLD Interface Configurations
MRT = Maximum Response Time, LLQI = Last Listener Query Interval
Interface Version Query MRT Robustness LLQI State
---------- ------ ------ ---- ---------- ----- --------
System 2 125 10 2 1 Disabled
n10 2 125 10 2 1 Enabled
n11 2 125 10 2 1 Disabled
n12 2 125 10 2 1 Disabled
Total Entries: 4
DGS-3620-28SC:admin#
To display the MLD configurations for interface “n10”:
DGS-3620-28SC:admin# show mld ipif n10
Command: show mld ipif n10
MLD Interface Details
Interface : n10
IPv6 Link-Local Address : FE80::123D:34AC/128
Querier : FE80::1E45:2310
Status : Enabled
Version : 2
Query Interval : 125 sec
Max Response Time : 10 sec
Robustness : 2
Last Listener Query Interval : 1 sec
Last Listener Query Count : 2
Startup Query Count : 2
Startup Query Interval : 31 sec
DGS-3620-28SC:admin#
64-3 show mld group
Description
This command is used to display the MLD group member table.
To Next Page
Loading...
