D-Link DGS-3620-52P - Page 76

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
71
Example
To display all authentication server groups:
DGS-3620-28SC:admin#show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
--------------- --------------- --------
mix_1 10.1.1.222 TACACS+
radius 10.1.1.224 RADIUS
tacacs 10.1.1.225 TACACS
tacacs+ 10.1.1.226 TACACS+
xtacacs 10.1.1.227 XTACACS
Total Entries : 5
DGS-3620-28SC:admin#
4-18 create authen server_host
Description
This command is used to create an authentication server host. When an authentication server host
is created, the IP address and protocol are the index. That means more than one authentication
protocol service can be run on the same physical host. The maximum supported number of server
hosts is 16.
Format
create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port <int
1-65535> | key [<key_string 254> | none] | timeout <int 1-255> | retransmit <int 1-20>}
Parameters
<ipaddr> - Specify the server host’s IP address.
protocol - Specify the server host’s type of authentication protocol.
tacacs - Specify the server host’s authentication protocol TACACS.
xtacacs - Specify the server host’s authentication protocol XTACACS.
tacacs+ - Specify the server host’s authentication protocol TACACS+.
radius - Specify the server host’s authentication protocol RADIUS.
port - (Optional) Specify the port number of the authentication protocol for the server host. The
default value for TACACS/XTACACS/TACACS+ is 49. The default value for RADIUS is 1812.
<int 1-65535> - Specify the port number of the authentication protocol for the server host. The
default value for TACACS/XTACACS/TACACS+ is 49. The default value for RADIUS is
1812. The port number must be between 1 and 65535.
key - (Optional) Specify the key for TACACS+ and RADIUS authentication.
<key_string 254> - Specify the key for TACACS+ and RADIUS authenticaiton. If the value is
null, no encryption will apply. This value is meaningless for TACACS and XTACACS.
none - No encryption for TACACS+ and RADIUS authenticaiton. This value is meaningless
for TACACS and XTACACS.
timeout - (Optional) Specify the time in seconds for waiting for a server reply. The default value
is 5 seconds.
<int 1-255> - Specify the time in seconds for waiting for a server reply. The default value is 5
seconds. The timeout value must be between 1 and 255 seconds.