DIR-300A Wireless N150 Router
User Manual
Configuring via Web-based Interface
The following elements are available on the page:
Parameter Description
IGMP
Select a version of IGMP from the drop-down list to enable IGMP.
Such a setting allows using the IGMP Proxy function for all WAN
connections for which the Enable IGMP Multicast checkbox is
selected.
To disable IGMP, select the Off value from the drop-down list.
SIP
Select the checkbox to enable SIP. Such a setting allows using the
SIP ALG function. This function allows VoIP traffic to pass through
the NAT-enabled router.
1
RTSP
Select the checkbox to enable RTSP. Such a setting allows managing
media stream: fast forward streaming audio/video, pause and start it.
PPPoE pass through Select the checkbox to enable the PPPoE pass through function.
PPTP pass through
Select the checkbox to enable the PPTP pass through function.
L2TP pass through Select the checkbox to enable the L2TP pass through function.
After specifying the needed parameters, click the Apply button.
1 On the Net / WAN page, create a WAN connection, on the Advanced / Miscellaneous page, select the SIP
checkbox, connect the phone cable between a LAN port of the router and the IP phone. Specify SIP parameters on
the IP phone and configure it to obtain an IP address automatically (as DHCP client).
Page 146 of 181
To Next Page
Loading...
