DIR-816 Wireless AC750 Dual Band Router with 3G/LTE
Support and USB Port
User Manual
Configuring via Web-based Interface
You can specify the following parameters:
Parameter Description
Name A name for the port for easier identification.
Enable
Move the switch to the right to allow using this group of ports.
Type
The type of the VLAN.
Untagged NAT. The group of this type is an external connection
with address translation. It is mostly used to transmit untagged
traffic. When this value is selected, the VLAN ID and QoS fields,
and the Tagged Ports section are not displayed. Only one group of
this type can exist in the system.
Tagged NAT. The group of this type is an external connection with
address translation. It is mostly used to connect to the Internet. Later
the VLAN which identifier is specified in the VLAN ID field is used
to create a WAN connection (on the Connections Setup / WAN
page). When this value is selected, the Untagged Ports section is
not displayed.
Bridge. The group of this type is a transparent connection between
an internal port and an external connection. It is mostly used to
connect IPTV set-top boxes.
VLAN ID
An identifier of the VLAN to which this group of ports will be
assigned.
QoS A priority tag for the transmitted traffic.
Untagged Ports
The section includes the ports that can be added to the group.
To add a port to the group, select the checkbox located to the left of
the relevant port.
To remove a port from the group, deselect the checkbox located to
the left of the relevant port.
Tagged Ports
Select an available value to assign it to this group. To do this, select
the checkbox located to the left of the relevant port.
Click the APPLY button.
To edit an existing group, select the relevant group in the table. On the page displayed, change the
parameters and click the APPLY button.
To remove an existing group, select the checkbox located to the left of the relevant line in the table
and click the DELETE button.
Page 151 of 215
To Next Page
Loading...
