D-Link DIR-842 - Specifications; Hardware Specifications; Software Features

DIR-842 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Gigabit
Router
User Manual
Overview
Specifications
*
Hardware
Processor
· RTL8197FH-VG (1GHz)
RAM
· 128MB, DDR2, built in processor
Flash
· 128MB, SPI NAND
Interfaces · 10/100/1000BASE-T WAN port
· 4 10/100/1000BASE-T LAN ports
LEDs · Power
· Internet
· 4 LAN LEDs
· WLAN 2.4G
· WLAN 5G
· WPS
Buttons · POWER button to power on/power off
· WIFI button to enable/disable wireless network
· WPS button to connect mesh network devices and set up wireless connection
· RESET button to restore factory default settings
Antenna
· Four external non-detachable antennas (5dBi gain)
MIMO
· 2 x 2, MU-MIMO
Power connector
· Power input connector (DC)
Software
WAN connection types · PPPoE
· IPv6 PPPoE
· PPPoE Dual Stack
· Static IPv4 / Dynamic IPv4
· Static IPv6 / Dynamic IPv6
· PPPoE + Static IP (PPPoE Dual Access)
· PPPoE + Dynamic IP (PPPoE Dual Access)
· PPTP/L2TP + Static IP
· PPTP/L2TP + Dynamic IP
Network functions · DHCP server/relay
· Advanced configuration of built-in DHCP server
· Stateful/Stateless mode for IPv6 address assignment, IPv6 prefix delegation
· Automatic obtainment of LAN IP address (for access point/repeater/client
modes)
· DNS relay
· Dynamic DNS
· Static IPv4/IPv6 routing
· IGMP/MLD Proxy
· RIP
· Support of UPnP IGD
· Support of VLAN
· WAN ping respond
· Support of SIP ALG
· Support of RTSP
· WAN failover
· Autonegotiation of speed, duplex mode, and flow control / Manual speed and
duplex mode setup for each Ethernet port
* The device features are subject to change without notice. For the latest versions of the firmware and relevant
documentation, visit www.dlink.ru.
Page 8 of 233