Section 3 – Web Configuration
SNMP
Choose ADVANCED > Network Tools > SNMP. The page shown in the figure
appears on the right. You can configure the SNMP parameters.
The following table describes the parameters of this page:
Enable SNMP
Select it to enable SNMP function. You need to
enable SNMP, and then you can configure the
parameters of this page.
Trap IP Address
Enter the trap IP address. The trap information is
sent to the corresponding host.
Community Name
(Read-only)
The network administrators must use this password
to read the information of this router.
Community Name
(Read-Write)
The network administrators must use this password
to configure the information of the router.
To Next Page
Loading...
