Statically Assign An IP Address
D-Link DSL-2640B User Manual 118
Statically Assign An IP Address
If you are not using a DHCP capable gateway/router, or you need to assign a static IP address, please follow the steps below:
Step 1
Windows® XP - Click Start > Control Panel > Network Connections.
Windows® 2000 - From the desktop, right-click My Network Places > Properties.
Step 2
Right-click the Local Area Connection that represents your D-Link network adapter and select Properties.
Step 3
Highlight Internet Protocol (TCP/IP) and click Properties.
Step 4
Click on the Use the following IP address and enter an IP
address that is on the same subnet as your network or the
LAN IP address on your router.
Example: If the router’s LAN IP address is 192.168.1.1, make
your IP address 192.168.1.X where X is a number between 2
and 254. Make sure that the number you choose is not in use
on the network. Set Default Gateway the same as the LAN IP
address of your router (192.168.1.1).
Set Primary DNS the same as the LAN IP address of your
router (192.168.1.1). The Secondary DNS is not needed or
you may enter a DNS server from your ISP.
Step 5
Click on the OK twice to save your settings.
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
