Web Configuration
D-Link DSL-2640B User Manual 12
Introduction to Web Configuration
The first time you setup the Router. It is recommended that you configure the WAN connection using a single computer, to ensure that both the computer and the Router
are not connected to the LAN. Once the WAN connection operates properly, you may continue to make changes to Router configuration, including IP settings and DHCP
setup. This chapter is concerned with using your computer to configure the WAN connection. The following chapter describes the various menus used to configure and
monitor the Router, including how to change IP settings and DHCP server setup.
Preparation Before Login
Before accessing the Modem, ensure the communication between PC and Modem is normal. Check the communication as follows.
Configure the IP address of the PC as 192.168.1.X (2~254), net mask as
255.255.255.0, gateway address as 192.168.1.1 (for customized version,
configure them according to the actual version).
Enter arp -a in the DOS window to check whether the PC can read the MAC
address of the Modem.
Ping the management IP address (192.168.1.1 by default) of the Modem.
If the PC can read the MAC address of the Modem and can ping through the
management IP address of the Modem, that means the communication of
the PC and the Modem is normal.
Note: When you manage the Modem through Web, you must keep the Modem power on. Otherwise, the Modem may be damaged.
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
