Web Configuration
D-Link DSL-2640B User Manual
30
In this page, you can modify the PPP username, PPP password, and authentication
method.
PPP Username: The correct user name that your ISP provides to you.
PPP Password: The correct password that your ISP provides to you.
PPPoE Service Name: If your ISP provides it to you, please enter it. If not, do
not enter any information.
Authentication Method: The value can be AUTO, PAP, CHAP, or MSCHAP.
Usually, you can select AUTO.
Dial on demand (with idle timeout timer): If this function is enabled, you
need to enter the idle timeout time. Within the preset minutes, if the modem
does not detect the flow of the user continuously, the modem automatically
stops the PPPOE connection. Once it detects the flow (like access to a
webpage), the modem restarts the PPPoE dialup. If this function is disabled,
the modem performs PPPoE dial-up all the time. The PPPoE connnection
does not stop, unless the modem is powered off and DSLAM or uplink
equipment is abnormal.
PPP IP extension: If you want to configure DMZ Host, you should enable it at
first.
Use Static IPv4 Address: If this function is disabled, the modem obtains an
IP address assigned by an uplink equipment such as BAS, through PPPoE
dial-up. If this function is enabled, the modem uses this IP address as the
WAN IP address.
IEnable NAT: Select the checkbox to apply Fullcone NAT mode.
Use Static IPv6 Address: Enable to use a static IPv6 address. Enter the
address in the
IPv6 Address field.
GMP Multicast: IGMP proxy. For example, if you want PPPoE mode to
support IPTV, enable it.
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
