DSL-2640T ADSL 2+ Router User Guide
84
WDS Mode Parameters
Bridge Mode
In bridge mode, the access point communicates only with other access
points. No wireless clients can associate with an access point in bridge
mode. In bridge mode, the access point has the option of acting as a
Root (click the Activate as Root box to enable). In Root mode the AP
becomes a primary link for the Wireless LAN to the Ethernet and Internet.
As the Root access point, there cannot be a wireless Uplink through the
AP. Only wireless Downlinks may be designated. To designate a Downlink,
enable up to 4 downlinks (Downlink 1 – 4) and type the MAC address of
the AP used for downlink in the space provided. Use Bridge mode if you
are using the access point to connect to a distant Ethernet LAN.
Repeater Mode
In repeater mode the access point can communicate with other access
points and wireless clients. Note that repeater mode will limit the amount
of throughput of wireless clients to the Ethernet. As with bridge mode,
repeater mode allows the AP to function as the Root.
Crude Mode
Crude Mode is recommended for wireless LANs using multiple vendors
wireless chip solutions. If wireless stations are using TI chips, use Bridge
or Repeater modes.
Note
Consider using a separate IP domain or VLAN for the Wireless LAN, especially when using
WDS. Wireless throughput can be severely affected by broadcasts (ARP requests) from the
Ethernet when using WDS.
To Next Page
Loading...
Need help?
General
