D-Link DSL-2740U User Manual

DSL-2740U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Configuring via Web-based Interface
LAN
To configure the router's local interface, go to the Connections Setup / LAN page.
IPv4
Go to the IPv4 tab to change IPv4 address, configure the built-in DHCP server, or specify MAC
address and IP address pairs.
Figure 76. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter Description
Local IP Address
IP address
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.1.1.
Subnet mask
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Device domain name The name of the device attached to its IP address in the local subnet.
Figure 77. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Page 97 of 174

D-Link DSL-2740U Specifications

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite downstream	up to 1.5 Mbps
G.lite upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 12 Mbps
ADSL full rate downstream	up to 24 Mbps
ADSL full rate upstream	up to 1 Mbps

Media Interface

ADSL interface connector	RJ-11
ADSL interface cable	24/26 AWG twisted pair
LAN interface connector	RJ-45
LAN interface standard	10/100BASE-T Ethernet