WAN - Static IP Address
Select this option to set static IP information provided to you by your ISP.
Static IP Address: Enter the static IP address assigned to you by your ISP.
IP Subnet Mask: Enter the IP subnet mask assigned to you by your ISP.
Gateway: Enter the gateway assigned to you by your ISP.
MTU: If you experience connection issues, you may need to change the MTU
setting for optimal performance with your specific ISP.
Default Route: Specifies the default route for the WAN interface.
NAT Enable: Enable or disable NAT function.
Enable PPPoE Passthrough: Enable or disable PPPoE pass through function.
IGMP Proxy: Enable or disable IGMP proxy function.
WAN - PPPoA/PPPoE
Select this option if your ISP requires you to use a PPPoA/PPPoE connection. This
option is typically used for DSL services. Select PPPoA/PPPoE to obtain an IP
address automatically for your PPPoA/PPPoE connection. Please enter the
information accordingly.
Please Note the image to the right shows PPPoE options. PPPoA WAN page may
differ slightly.
Username: Enter the username for your product.
Password: Enter the password for your product.
Confirm Password: Enter the confirm password.
MTU: If you experience connection issues, you may need to change the MTU
setting for optimal performance with your specific ISP.
TCP MSS: Specifies the maximum segment size for the PPPoE connection.
Default Route: Specifies the default route for the WAN interface.
NAT Enable: Enable or disable NAT function.
Enable PPPoE Passthrough: Enable or disable PPPoE pass through function.
IGMP Proxy: Enable or disable IGMP proxy function.
Connection: Specifies the PPPoE connect mode.
Get IP Address: Select the way to get IP address. It is static or dynamic.
Static IP Address: Enter the static IP address.
IP Subnet Mask: Enter the IP subnet mask.
Gateway: Enter the gateway.
To Next Page
Loading...
