D-Link DSL-2878 - Ethernet

30D-Link DSL-2878 User Manual
Section 4 - Conguration
Ethernet
Your DSL-2878 is equipped with a multi-purpose Gigabit Ethernet LAN/WAN port which
can be used to connect to the Internet. This port may be used to connect to other Ethernet
based networks. In order for your DSL-2878 to use Ethernet, you must congure the Ethernet
Settings and your WAN Settings.
WAN Settings
Service Number: Select a service number from the drop-down menu, or to create a
new service number, click Add.
Enable Virtual
Circuit
Enable or disable virtual circuit, also referred to as VLAN tagging.
If you selected Enable Virtual Circuit, the following options are available:
VLAN ID: Enter the VLAN ID. The value should be 0, or 0-4079.
Proceed to IPv4 Settings on page 31 or IPv6 Settings on page 82.