D-Link DSL-2878

50D-Link DSL-2878 User Manual
Section 4 - Conguration
Application
Port triggering allows ports to be opened when trac is detected on specied
ports. This is used for facilitating communication between applications and
servers behind a NAT rewall. To access this page, click Application from the
Features menu on the bar on the top of the page.
The currently dened Application rules are displayed in the table. Some
commonly used Applications are pre-congured by default. You may create
up to eight application rules. If you wish to remove an application rule, click
on its trash can icon in the Delete column. If you wish to edit an application
rule, click on its pencil icon in the Edit column. If you wish to create a new
application rule, click the Add Rule button.
Create New Rule
Enable
Application:
Enable or disable the Application rule.
Name: Enter a name for this application.
Trigger Port Start: Enter the starting port range trac will be forwarded from.
Trigger Port End: Enter the ending port range trac will be forwarded from.
Trigger Trac
Protocol Type:
Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Open Port: Enter the port or port range to open once triggered.
Open Trac
Protocol Type:
Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Click Apply when you are done.