D-Link DSL-2878 - Pppoe

33D-Link DSL-2878 User Manual
Section 4 - Conguration
PPPoE
Select PPPoE if your ISP provides and requires you to enter a PPPoE username
and password in order to connect to the Internet.
WAN Settings
Connection: Select PPPoE.
WAN Service Type: Select a service type from the list. As of this writing, only Internet is
supported for manual conguration.
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Connection Type: Select PPPoE LLC or PPPoE VC-Mux.
IP Control: Select Dynamic IP Address or Static IP Address.
If you selected Static IP Address, the following option is available:
Static IP Address: Enter the IP address provided by your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
NAT Enable: Enable or disable Network Address Translation.
Authentication
Protocol:
Select the authentication protocol your ISP uses. The options are
Auto, PAP, or CHAP.
Connect mode
select:
Set the connection to be Always-on, Connect-On-Demand, or
Manual.