Unified Services Router User Manual
116
Chapter 9. Administration &
Management
9.1 Configuration Access Control
The primary means to configure this gateway via the browser-independent GUI. The
GUI can be accessed from LAN node by using the gateway‘s LAN IP address and
HTTP, or from the WAN by using the gateway‘s WAN IP address and HTTPS (HTTP
over SSL).
Administrator and Guest users are permitted to login to the router‘s management
interface. The user type is set in the Advanced > Users > Users page. The Admin or
Guest user can be configured to access the router GUI from the LAN or the Internet
(WAN) by enabling the corresponding Login Policy.
Figure 75: User Login policy configuration
9.1.1 Remote Management
Both HTTPS and telnet access can be restricted to a subset of IP addresses. The
router administrator can define a known PC, single IP address or range of IP
addresses that are allowed to access the GUI with HTTPS. The opened port for SSL
traffic can be changed from the default of 443 at the same time as defining the
allowed remote management IP address range.
To Next Page
Loading...
